RS PRO Non Contact Voltage Indicator, 230V ac to 1000V ac
技術文件
規格
Brand
RS ProIndicator Type
Voltage
Battery Type
AAA
ATEX Approval
Yes
Power Source
Battery
Safety Category
CAT III 1000 V ac
Weight
50g
Diameter
18mm
Length
151mm
Maximum Detection Voltage
1000V ac
Minimum Detection Voltage
230V ac
Maximum Operating Temperature
+40°C
Safety Category Level
CAT III
Minimum Operating Temperature
-20°C
Safety Category Voltage
1000V ac
原產地
Denmark
產品詳情
RS Pro Volt Stick Non-Contact Voltage Detector
The Non-Contact VoltStick® is a tester for safely checking the presence of an AC voltage without making any disconnections in cables, wall sockets, fuses, circuit breakers, junction boxes etc. No current flow is needed for correct detection. Apply the plastic tip to any connection point or move it along an insulated cable. When an AC voltage is detected a red indicator in the plastic tip illuminates, as it detects the live wire through the insulation. Note that if a 3 phase machine is connected up and one of the fuses blows, the voltage is conducted back to the defective fuse the other way and a faulty indication may be given. Make sure that all machines are disconnected before testing. The VoltStick® cannot be used on socket with shielded cable.
453.50 MOP
453.52 MOP Each (不含稅)
Calibration type
No Calibration
1
453.50 MOP
453.52 MOP Each (不含稅)
暫時無法取得庫存資訊。
Calibration type
No Calibration
1
暫時無法取得庫存資訊。
| 數量 | 單價 |
|---|---|
| 1 - 4 | 453.52 MOP |
| 5+ | 373.25 MOP |
技術文件
規格
Brand
RS ProIndicator Type
Voltage
Battery Type
AAA
ATEX Approval
Yes
Power Source
Battery
Safety Category
CAT III 1000 V ac
Weight
50g
Diameter
18mm
Length
151mm
Maximum Detection Voltage
1000V ac
Minimum Detection Voltage
230V ac
Maximum Operating Temperature
+40°C
Safety Category Level
CAT III
Minimum Operating Temperature
-20°C
Safety Category Voltage
1000V ac
原產地
Denmark
產品詳情
RS Pro Volt Stick Non-Contact Voltage Detector
The Non-Contact VoltStick® is a tester for safely checking the presence of an AC voltage without making any disconnections in cables, wall sockets, fuses, circuit breakers, junction boxes etc. No current flow is needed for correct detection. Apply the plastic tip to any connection point or move it along an insulated cable. When an AC voltage is detected a red indicator in the plastic tip illuminates, as it detects the live wire through the insulation. Note that if a 3 phase machine is connected up and one of the fuses blows, the voltage is conducted back to the defective fuse the other way and a faulty indication may be given. Make sure that all machines are disconnected before testing. The VoltStick® cannot be used on socket with shielded cable.